Element4 Lucius 140 RD MKII Installation, Operation And Owner's Manual page 51

Direct vent
Hide thumbs Also See for Lucius 140 RD MKII:
Table of Contents

Advertisement

MAINTENANCE
Step 3.
Attach suction cup to the center of the glass and lift the glass up into the clearance
notch.
When the glass panel is raised into the clearance notch there is enough clearance
to swing the lower edge of the glass panel over the standoff frame.
When the glass panel is outside of the standoff frame then lower the glass panel
out of the clearance notch and carefully, and securely, set the panel aside.
Step 4.
Repeat Steps 2 and 3 for the other glass panels.
CLEANING THE GLASS
The glass should be cleaned as necessary with a fireplace glass cleaner.
We recommend Stove Bright® Gas Appliance Glass Cleaner by Forrest
Paint Co. It is available through your retailer.
Glass Panel
Follow the instructions for use and do not clean the glass when it is hot!
If the glass becomes coated with deposits which cannot be removed it
must be replaced.
Standoff Frame
INSTALLING THE GLASS
The glass panels should be installed in reverse order of their removal
Firebox Gasket
beginning with the largest glass panel.
Step 1.
Lift the glass panel up into the clearance notch and swing the lower edge of the glass panel against the firebox gasket. Set a glass
clamp into place and hold it loosely into place with a retaining bolt. DO NOT tighten the retaining bolt yet.
Step 2.
Repeat Step 1 with the remaining glass panels.
Step 3.
Center the glass panel, left and right, on the fireplace and screw the retaining bolts into the lower glass clamp until the bolts touch
the glass clamp. Repeat for the remaining glass clamps on this glass panel.
Step 4.
Slide the adjoining glass panel against the installed glass panel. If there is a second adjoining glass panel slide it into place like the
others.
Step 5.
While ensuring that the glass panels are tight and square to each another, tighten the retaining bolt(s) on each clamp NO MORE
THAN 1/2 TURN past finger tight.
PROPERLY PLACE, CLAMP AND SEAL THE GLASS PANEL(S) BEFORE LIGHTING THE FIRE!
51
Element4 Gas Fireplaces
EuropeanHome.com

Advertisement

Table of Contents
loading

Table of Contents