Element4 Lucius 140 RD MKII Installation, Operation And Owner's Manual page 58

FUNCTION
D.
Pilot lit.
Yes
E.
Sparking stops after
pilot is lit.
Yes
F.
Motor turns to main
gas and pilot stays
lit.
Yes
(continued)
Element4 Gas Fireplaces
APPENDIX TWO
TC- and SW-cable reversed.
No
Magnet unit not operating properly.
Short between interrupter and SW cable.
No gas (magnet unit drops after 30 second
audible count.)
Spark not lighting the pilot.
Short between interrupter block and TC-
cable.
No
Electronic measuring amplifier defective.
Resistance in thermocouple circuit too
No
high.
Magnet
unit
drops
(audible
sound)
Not enough heat on thermocouple.
Low voltage from thermocouple.
No gas (magnet unit drops after 30
second audible count.)
No Broken receiver
Ignition sequence stops.
No reaction to remote command.
No
Element4 '140' models ONLY: Pilot flame
under hearth panel not establishing.
POSSIBLE CAUSE
Check cable connection between receiver
and interrupter block.
Replace gas valve.
Check interrupter block connection.
Check gas supply.
Check spark is crossing pilot orifice.
Check connection to interrupter block.
Replace the receiver.
Check thermocouple circuit.
Check position of pilot to thermocouple.
Check the stability and intensity of pilot flame.
Ensure the proper restrictor is installed.
Ensure that the pilot flame is properly
adjusted.
Possible cold start
Replace thermocouple. Do not over tighten -
hand tight plus 1/4 turn maximum.
Check gas supply.
Ensure powered/unpowered receiver allows
manual operation.
Reset system, see the installation manual or
the label on the receiver.
Do not coil the ignition cable.
Remove hearth panel and glass and check
for proper pilot operation. If pilot establishes
with panel off then install panel and glass
and adjust pilot flame (hi/lo) for best
operation.
58
REMEDY
EuropeanHome.com