Adjusting The Horizontal Time Scale And Trigger Position - Keysight Technologies Z Series User Manual

Adjusting the Horizontal Time Scale and Trigger Position

Use the horizontal controls to configure the oscilloscope's horizontal scale (time
per division) and horizontal position of the waveform. You can view a magnified
section of the waveform using the zoom window.
Use gestures on the touch screen to adjust the waveform horizontal scale and
position. You can also use the horizontal knobs, the horizontal controls, or the
Horizontal Setup dialog box.
Figure 19 Front Panel Horizontal Scale and Position Knobs, [Zoom] key
Figure 20 User Interface Horizontal Controls
Infiniium Z-Series Oscilloscopes User's Guide
Push
for Vernier
Horizontal scale knob—
adjusts time per division
Access the Horizontal
Setup dialog box
Set horizontal scale
Magnifies a part of the waveform
in a new window
Horizontal
Zoom
Horizontal position knob—
adjusts delay between
trigger and center screen
Turn Zoom mode on/off
Set horizontal position
(delay)
Using the Oscilloscope
Push
to Zero
2
39