Related Manuals for Oxgard Praktika T-02
Summary of Contents for Oxgard Praktika T-02
- Page 1 MAINTENANCE OPERATIONS Praktika T-02(К) turnstile www.oxgard.com info@oxgard.com Tel.+7(812) 366-15-94...
-
Page 3: Table Of Contents
Contents 1. General information ................. 4 2. Conditions for maintenance ..............5 3. Partial disassemble of the turnstile ............5 4. Checking turnstile parts ................. 15 5. Lubrication of moving parts ..............16 6. Assembling and performance checking of the turnstile ......16 Maintenance operations... -
Page 4: General Information
1.4. MO includes the following scope of work: partial disassemble of the turnstile, cleaning of load-bearing frame, checking of parts and units fixation, lubrication of subject to wear parts of actuating device, checking of belt tension, setting the dismantled parts and a general inspection of the turnstile. Praktika T-02(К) turnstile... -
Page 5: Conditions For Maintenance
2. Conditions for maintenance CAUTION! It is strictly forbidden to carry out work with powered turnstile. Failure to follow these safety requirements could result in damage to human life and health, total or partial loss of product workability and (or) auxiliary equipment. CAUTION! Do not remove motherboard located under the LED panel. - Page 6 Fig. 1 Press the button 4 on the RC panel (Fig. 2) and fold the arms. The result is shown in Fig. 3. 3.2 Turn off turnstile power supply and disconnect it from the electrical network. Praktika T-02(К) turnstile...
- Page 7 Fig. 2 Fig. 3 3.3. Open using the key and remove the cover with locks (see Fig. 1). 3.4 Removing turnstile cover: Maintenance operations...
- Page 8 • Remove two self-tapping screws using a crosshead screwdriver with a magnetic tip (Fig. 4) CAUTION! Make sure that the fittings do not fall into the turnstile mechanism. • slide the turnstile cover in the direction indicated by Fig. 5, and lift it up. Fig. 4 Praktika T-02(К) turnstile...
- Page 9 Fig. 5 Maintenance operations...
- Page 10 Fig. 6 Praktika T-02(К) turnstile...
- Page 11 Fig. 7 Fig. 8 Maintenance operations...
- Page 12 Fig. 9 Praktika T-02(К) turnstile...
- Page 13 Fig. 10 Maintenance operations...
- Page 14 Fig. 11 Fig. 12 Praktika T-02(К) turnstile...
-
Page 15: Checking Turnstile Parts
Fig. 13 3.5. Removing the bottom cover of turnstile: • Remove two M6 DIN7985 screws (Fig. 6); • Remove one M6 GOST11738-84 screw (Fig. 6); • Remove the bottom cover by moving it vertically down, as shown in Fig. 4. Checking turnstile parts 4.1. -
Page 16: Lubrication Of Moving Parts
(RAL9005) shall be used in accordance with instructions for its use. 6.3. Reassemble the turnstile in reverse order. 6.4. Turn on the turnstile and perform functionality check by making several passes and activating “antipanic” mode. Praktika T-02(К) turnstile... - Page 17 6.5. If there is no extraneous noise or any abnormality in the turnstile work it is ready for operation. Maintenance operations...
- Page 18 Praktika T-02(К) turnstile...
- Page 19 Maintenance operations...
- Page 20 OOO "Vozrozdenie" 192289 Saint Petersburg Sofiyskaya st., 66 Tel./fax +7 (812) 366 15 94 www.oxgard.com info@oxgard.com...
Need help?
Do you have a question about the Praktika T-02 and is the answer not in the manual?
Questions and answers