Related Manuals for Oxgard CUBE C-10
Summary of Contents for Oxgard CUBE C-10
- Page 1 VOZROZHDENIE LLC OKPD 2 26.30.50.110 TU 26.30.50-007-33120038-2017 APPROVED BY VZR.249600.000LU FULL HEIGHT ROTOR TURNSTILE CUBE C-10 MODEL VZR.249600.000OM OPERATION MANUAL 40 sheets 2021...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Description and operation ......................4 1.1 Product description and operation ..................4 1.2 Description and operation of Oxgard Praktika control panel ..........10 Intended use ..........................11 2.1 Operating limits ........................11 2.2 Preparing the product for use ....................12 2.3 Product operation ......................... - Page 3 VZR.249600.000OM This Operation Manual (OM) applies to Oxgard Cube C-10 full height rotor turnstile and its modifications (hereinafter referred to as the product). Product firmware version: FС C-10 The manufacturer reserves the right to change configuration, technical characteristics and appearance of the product without further notice Before using the product, please read the Logbook VZR.249600.000 LB as...
-
Page 4: Description And Operation
To ensure convenient and fast passage of people, it is recommended to install one product per 300 people working during one shift. 1.1.2 The product structure is provided in Table 1. Cube C-10 full height rotor turnstile Operation Manual... - Page 5 UCP 02* Universal control panel 02 Reader for PC* Z2-USB Barrier section set* Praktika barrier Bracket* Fastening bracket to turnstile Key for unlocking lock Note - Product components marked with (*) are optional. Cube C-10 full height rotor turnstile Operation Manual...
- Page 6 Maximum number of connected control panels, pcs. Width of blocked passage, mm 1455 Number of rotor blades, pcs. Number of horizontal rods in blade, pcs. Length of rotor blade rod, mm Passage height, mm 2015 Service life, years Cube C-10 full height rotor turnstile Operation Manual...
- Page 7 (color as selected). Figure 1 – General view of the turnstile The turnstile consists of: fixed fencing panel (Figure 1 – 1); moving fencing elements – rotor gate (Figure 1 – 2); Cube C-10 full height rotor turnstile Operation Manual...
- Page 8 Figure 2 – initial position of the flaps: – when the turnstile is in initial state, passage area is covered by one panel without forming a gateway; Figure 2 – Initial position of the flaps Cube C-10 full height rotor turnstile Operation Manual...
- Page 9 Appearance of the indication panel Marking contains manufacturer’s trademark, designation, and 1.1.6 serial number. 1.1.7 Overall dimensions of the packaging container are: box No. 1 (HхWхL) 420Х1070Х1500; box No. 2 (HхWхL) 565Х890Х2130. Cube C-10 full height rotor turnstile Operation Manual...
-
Page 10: Description And Operation Of Oxgard Praktika Control Panel
VZR.249600.000OM Description and operation of Oxgard Praktika control panel Universal Oxgard Praktika control panel is designed for controlling Oxgard turnstiles. 1.2.1 The housing is made of stainless steel and the control buttons and operating mode LED indicators are located on the front side. The specifications are given in Table 3. -
Page 11: Intended Use
USER FAILS TO COMPLY WITH THE SAFETY REQUIREMENTS SPECIFIED IN THIS SECTION, AND ALSO VOIDS THE PRODUCT WARRANTY. DO NOT: OPERATE THE TURNSTILE IN CONDITIONS NOT MEETING THE REQUIREMENTS TO THE OPERATING CONDITIONS. Cube C-10 full height rotor turnstile Operation Manual... -
Page 12: Preparing The Product For Use
TURNSTILE ELEMENTS ROTATION AREA FROM PEOPLE AND FOREIGN OBJECTS. 2.2.2 Rules and procedures for visual inspection of the product Visual inspection of the product before connecting it to the mains shall be obligatory and include: Cube C-10 full height rotor turnstile Operation Manual... - Page 13 An indication blinks on the turnstile indication panel indicating the side to which the turnstile must be turned to reach the zero position. Cube C-10 full height rotor turnstile Operation Manual...
- Page 14 The turnstile is ready to work. Check the product operation in all modes. 2.2.4 Control panel appearance Figure 5 – control buttons 1 (LEFT), 2 (STOP), 3 (RIGHT), 4 (ANTIPANIC) and LED indicators of the product operating modes. Cube C-10 full height rotor turnstile Operation Manual...
-
Page 15: Product Operation
Work with ACS is considered in the Installation Manual. 2.3.2 Controlling the product using the control panel Figure 5 – over each CP button, there is a LED indicator that displays the turnstile operating mode. Cube C-10 full height rotor turnstile Operation Manual... - Page 16 It is also possible to authorize a single pass into the non-authorized direction by pressing button 1 (3). The product will return to the original mode after this passage or within 8 seconds. Cube C-10 full height rotor turnstile Operation Manual...
- Page 17 Table 4 – Turnstile settings using UCP 02 Function or operating mode Buttons combination Free passage to the left Short synchronous pressing (2-3 sec) Left Stop Free passage to the right Short synchronous pressing (2-3 sec) Stop Right Cube C-10 full height rotor turnstile Operation Manual...
- Page 18 Control panel sound switch on/off - 1 beep (flashing backlight) 8 seconds Left, stop, right, anti-panic Factory Reset (Remote) - 2 beeps (backlight blinking) 16 seconds Reverse remote control buttons (8 seconds) Left, stop, right Running Autotest 16 seconds Cube C-10 full height rotor turnstile Operation Manual...
-
Page 19: Emergency Procedures
ELECTRIC CIRCUIT CAN BE A SOURCE OF FIRE DANGER IN CASE OF SHORT CIRCUIT, INSULATION BREAKDOWN AND SPARKING. In case of fire, switch external power supply off. Use powder extinguishers to extinguish fire in the product, wiring and cables. Cube C-10 full height rotor turnstile Operation Manual... -
Page 20: Maintenance
3, and who have read and understood this Operation Manual. Safety precautions When performing maintenance, safety measures shall be observed. Maintenance shall be performed by specially trained technical personnel. Cube C-10 full height rotor turnstile Operation Manual... -
Page 21: Product Maintenance Procedure
Product maintenance procedure Maintenance includes the following scope of work: visual inspection of the product condition; partial disassembly of the turnstile, cleaning of the supporting frame; checking fastening parts and assemblies of the turnstile; Cube C-10 full height rotor turnstile Operation Manual... -
Page 22: Visual Inspection Of The Product
Clean inner parts of the upper module from dirt. 3.6.3 Check that all cables are securely attached. 3.6.4 Check and, if necessary, tighten threaded connections of the fasteners of the turnstile assemblies. Cube C-10 full height rotor turnstile Operation Manual... -
Page 23: Lubricating Moving Parts Of The Product Mechanism
‘Anti- panic’ mode. If extraneous noise and any violations of operating modes are absent, the turnstile is ready for operation. Cube C-10 full height rotor turnstile Operation Manual... - Page 24 List of addresses of official distributors and service centers is given in Appendix A and is also available at the website: www.oxgard.ru If it is necessary to repair (for T-10 product only) damaged painted surfaces, use powder paint identical to the damaged one (RAL9005) in accordance with the paint instructions for application.
-
Page 25: Routine Repairs
If any other problems occur, contact service department. Routine repairs of the product components Routine repairs of the product components shall be carried out by replacing faulty parts with known good ones. When such replacement is impractical or there Cube C-10 full height rotor turnstile Operation Manual... -
Page 26: Malfunctions During Warranty Period
VZR.249600.000 LB), please send a claim to the manufacturer. To do this: prepare a technically substantiated Claim Report; make extracts from the LB section “Repair”. make extracts from the LB section “Preservation”. Cube C-10 full height rotor turnstile Operation Manual... -
Page 27: Storage
The product shall be stored in dry (without moisture condensation) rooms at a temperature from -40 to + 50 °C. The storage room should be free of acid or alkali vapors, or corrosive gases. Cube C-10 full height rotor turnstile Operation Manual... -
Page 28: Transportation
When transporting and storing products on Euro pallets, it is allowed to stack boxes in 2 rows. Loading and unloading operations should be carried out in compliance with safety regulations. Cube C-10 full height rotor turnstile Operation Manual... -
Page 29: Disposal
Examples of such disposal can be product disassembly (dismantling) and sorting its components into groups of similar parts, converting the product into a learning aid or using for purposes other than intended use. Cube C-10 full height rotor turnstile Operation Manual... -
Page 30: Appendix A - Distributors And Service Centers
Orenburg Tract, 128, bld. 1 Distributor 7 (843) 204‒22‒33 Luis + LLC Warehouse www.luis.ru luis@luis.ru 603086, Nizhny Novgorod, Manufakturnaya st., 14, room 1 Distributor 7 (831) 214 ‒71‒17 Luis + LLC Warehouse www.luis.ru luis@luis.ru Cube C-10 full height rotor turnstile Operation Manual... - Page 31 Professor Popov st., 4 Dealer Ravelin LTD. 7 (812) 327-50-32 Service center ravelin@ravelinspb.ru, www.ravelinspb.ru 123181, Moscow, Isakovsky st., 33, bld. 3 Corporate Business 7 (495) 234-68-51 Dealer Systems www.cbs-group.ru sales@cbs- Service center group.ru Cube C-10 full height rotor turnstile Operation Manual...
- Page 32 7 (831) 272‒55‒75 7 (831) 412‒93‒11 Satro-Paladin LLC Dealer www.satro-paladin.com dir@nn.satro-paladin.com 603070, Nizhny Novgorod, Meshchersky Ave., 7, bld. 3, office 10 7 (831) 272‒55‒75 7 (831) 412‒93‒11 Satro-Paladin LLC Dealer www.satro-paladin.com dir@nn.satro-paladin.com Cube C-10 full height rotor turnstile Operation Manual...
- Page 33 InfoTec LLC 7 (812) 327 95 10 7 (812) 327 95 06 Dealer www.infotec.ru contact@infotec.ru 196105, St. Petersburg, Lyubotinsky Ave., 5, Letter “B”, office 310 ForTrade LLC Dealer 8 (812) 309-58-53 www.fteq.ru 4trade@fteq.ru Cube C-10 full height rotor turnstile Operation Manual...
- Page 34 Dealer www.grumant.ru krim1@grumant.ru krim2@grumant.ru Dealer 644046, Omsk, Mayakovsky st., 14 Modus Trade LLC 7 (3812) 51-00-93 7 (3812) 51-07-29 Table 7 – Foreign distributors and service centers Item Company Contact details Status Cube C-10 full height rotor turnstile Operation Manual...
- Page 35 Minsk, Petr Glebka st., 1 Dealer Systems Unitary 375 (17) 390-66-66 (multi-line) Service center Enterprise Mob.: +375 (33) 340-11-11 (MTS) www.sob.by info@sob.by Mustamäe tee 102-106 Tallinn Harjumaa 12917 OÜ Almasel Service center Tel +372 59192909 info@almasel.com Cube C-10 full height rotor turnstile Operation Manual...
-
Page 36: Abbreviations
IM — Installation Manual; PSU — power supply unit; control panel symbol; — BCP 01 — basic control panel; UCP 02 universal control panel; — ACS — access control system; MNT — maintenance. Cube C-10 full height rotor turnstile Operation Manual... - Page 37 VZR.249600.000OM Cube C-10 full height rotor turnstile Operation Manual...
- Page 38 VZR.249600.000OM Cube C-10 full height rotor turnstile Operation Manual...
- Page 39 Vozrozhdenie LLC 192289, 66, Sofiiskaya str., Saint-Petersburg, Russia Telephone/Fax +7 (812) 366 15 94 www.oxgard.com info@oxgard.com...
Need help?
Do you have a question about the CUBE C-10 and is the answer not in the manual?
Questions and answers