Page 4
List of abbreviations – power supply – fire alarm – remote control – access control system – operating device Speedgate firmware version FW v1.4-2.2 Card collector firmware version FWv1.52 Praktika T-04(K) speedgate...
1. Product purpose Praktika-T-04 speedgate is designed for access control and pedestrian flow management. The speedgate can be used at checkpoints at factories and organizations, institutions, banks, schools, sports and entertainment facilities, shops, railway stations, etc. To ensure easy and quick passage of people it is recommended to install one speedgate for every 500 people working in one shift.
3. Basic specifications Table 2 Basic specifications Description Speedgate RC panel Dimension of side unit with open wings 1140х1500х200 107х107х25 (mm) (HхWхL) Dimension of side unit depending on passage lane (mm) 107х107х25 1140х1500х500 1140х1500х620 Weight of side unit depending on passage lane, kg 110,0 113,0...
Table 3 Electrical specifications Description Speedgate Card collector** RC panel Supply voltage, V: - nominal 12,0 12,0 12,0 - working 10,8...15,0 7,5...15,0 8…18,0 Average current in standby mode * A Average current operational mode * A Maximal current of 1 side unit*/***, A Maximal current...
Page 8
Fig. 1 General view of speedgate Praktika T-04(K) speedgate...
Page 9
LED panel Display panel of the speedgate is made of artificial stone with an insertion made of acrylic glass. Speedgate operating modes are displayed on the panel in the form of mnemonic signs depicting authorization and non-authorization of passage (Fig. 2). Fig.
Fig. 3 General view of remote control 5. Transportation and storage Speedgate in its original packaging shall be transported by air, by road and by railroad with protection from direct exposure to rain and dust without range limitation. It is allowed to stack boxes in 2 rows during transportation and storage if Euro-pallets used.
6. Safety requirements CAUTION! Failure to comply with the safety requirements specified in this section may result in damage to human life and health, total or partial loss of workability of products and (or) auxiliary equipment. CAUTION! Specific guidance on the use of the speedgate: 1.
CAUTION! The producer disclaims any liability for damage to human life and health, total or partial loss of workability of products and (or) auxiliary equipment for non-compliance of the safety requirements specified in this section, as well as terminate the product warranty. IT IS NOT ALLOWED TO: •...
7.2. Product design Fig 4. General view of the card collector In front of the housing there is a hatch with lock for quick access to collected cards and to the board where PS, OD and ACS cables are connected. The hatch has card storage device where more than 500 cards can be stored.
7.3. Removing guest cards from card collector 7.3.1. Open the hatch lock of card collector with a key (Fig. 4). 7.3.2. Put a bag to collect cards (not supplied) underneath storage device. 7.3.3. Lift the storage shutter to remove cards. 7.3.4.
Page 15
"Stop" mode "Stop" mode is set when the speedgate is turned on. Wings are closed. Switch from another mode to "Stop" is performed by pressing button 2, in this case LED indicator above button 2 turns red. In this mode the passage is non-authorized in both directions.
Free passage mode In order to swich to this mode press and hold button 1, then press button 3 and release both buttons. In this mode an unlimited number of passages is allowed in both directions. Arrows turn on in both directions. Green LED indicators on the RC panel LED turn on above the button 1 and 3.
8.5. Control with card collector The card collector is set in the standby mode after power-up. It is necessary to present access card to switch the mode. Passage with permanent cards When an authorized permanent visitor card is presented to the reader card collector unlocks the speedgate for the time specified by ACS controller (depending on the operating mode;...
Page 18
Passages with permanent cards are performed normally. In order to switch the card collector in the standard operating mode, remove cards from the storage device (see. Article 7.3). Emergency mode During the operation of the card collector there might be a situation when a card or a foreign object becomes jammed by shutter of the card collector.
Appendix 1. Troubleshooting for speedgate Table 7. Troubleshooting for the speedgate Fault Remedy PS unit is connected, but Check the connection cable; Check the fuses on motherboard the speedgate does not work RC panel does not work Check the RC panel connection; +12 and GND contacts are connected properly try to interchange positions of CL and CH;...
Page 20
Table 8. Troubleshooting for the card collector Fault Possible Remedy causes PS unit is connected, Check the connection cable; Check the fuse on board of the card collector; but the card collector does not work Storage Act in accordance with article 7.3; device is full Check the condition of the cables and connectors;...
Page 21
Act in accordance with the article 8.5, Card or "Emergency mode". foreign object is left in card hole Card collector of card provides 5 audio collector signals, red cross on the LED panel is Check the voltage at the connectors blinking (without removing the connectors, while (then red cross on the...
Need help?
Do you have a question about the Praktika T-04K and is the answer not in the manual?
Questions and answers