Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Charge the Hydraulics
1. Attach the finisholl to a tractor sized for field
operation and connect the lift cylinder hoses. Charge
the lift system with hydraulic oil as described in
Figures 3-22
and
"Hydraulic Lift System" on
page
4-2.
2. For the optional hydraulic gang adjustment – connect
the gang cylinders hoses to the tractor and charge
the cylinders with oil
3-27. Charge the hydraulic disc gangs with oil before
attempting to fold the finisholl
Gang System" on page 4-4.)
carefully when initially charging with oil to make sure
the gang do not bottom out on the frame when
cycling. Disc gangs may require leveling before being
able to fully cycle.
3. Connect the fold system hoses to the tractor and
charge the fold cylinders
3-21. When fold cylinders have been charged with
oil, connect the rod end of the fold cylinders to the
wing frames using 1-1/4 x 6-1/8 pins, flat washers
and roll pins
"Hydraulic Fold System" on page
3-28
See Figures 3-25
through
(See "Hydraulic Disc
Watch the disc gangs
See Figures 3-18
through
Final Assembly
1. Install the appropriate harrow(s) as described,
Figure 2-10
2. Inflate all tires to proper inflation pressure
"Model Specifications" on page
3. Level the finisholl wings to the center frame and from
front-to-rear
page 4-9.)
and
page 4-8.)
4. Level the disc gangs
Gangs" on page 4-5.)
5.
Adjust disc scrapers
on page 4-12.)
6. Grease the unit at all points listed in
and
Table
4-1.)
4-3.
through 2-92.
2-1.).
(See "Leveling (Front-to-Rear)" on
(See "Leveling (Side to Side)" on
(See "Leveling Hydraulic Disc
(See "Scraper Adjustment"
See Figure 4-15
See
(See
F-756-0321
Advertisement
Table of Contents
