Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Shank Installation
See Figures 2-1
-
2-8
for shank placement dimensions.
Verify that all shank clamps are properly installed.
1. Install pr reposition any shanks and extensions that
may have been turned around for shipping.
2. Install shanks in clamps
a. Spring clamp assembly - Install shank in clamp
using 5/8-11 X 1-3/4 round head square neck
screw and flange lock nut provided.
b. Install shank clamp, 1/2-13 x 3-1/4 hex head cap
screw, and hex lock nut across bottom of shank
clamp weldment.
c. S-tine clamp assembly - Install shank in S-tine
spring using 5/8-11 X 2-1/4 hex head cap screw
and hex lock nut provided.
3. Install sweep on shank with 7/16-14 X 1-1/2 plow
bolt, washers, and nuts provided. Note that the flat
washer is only used in the lower slotted sweep hole.
3-26
See Figures
3-29.
NOTE
Verify that springs have been set to the proper tension.
Adjust the spring until there is 1/8" gap between the top
of the mount and locking jam nut on top of the spring
Figure
3-28. Lock the jam nut against the top of the
spring, not the top of the mount. Torque main pivot bolt to
140 FT-LBS.
1/8"
Figure 3-28: Spring Adjustment
See
5/8 X 3 BOLT
SPRING PLATE
5/8 JAM NUT
SPRING
ASSEMBLY
SHANK CLAMP
WELDMENT
MAIN PIVOT
BOLT
F-756-0321
Advertisement
Table of Contents
