Landoll 8530 Operator's Manual page 122

ASSEMBLY INSTRUCTIONS
Hydraulic Installation
1. Install the hydraulic manifolds at the center and rear
of the center frame to the mounts welded to the
frames using 1/2 x 3-1/2 bolts and locknuts.
2. Install 90 degree regular adapter fittings in both ends
of all lift cylinders. Install the lift cylinder hoses as
shown in Figures 3-22
hoses along the right side of the hitch, and through
the hose loops provided along the frames. Wrap the
two ends of the lift hoses with a blue hose wrap.

Restrictors are installed in the rod end of wing
fold cylinders to prevent uncontrolled dropping
of wings. Removal of these restrictors, or
improper installation can result in series damage
to the implement.
3. Install the fold cylinder hoses as shown in
Figures 3-18 through 3-21. Route the hoses along
the right side of the hitch, and through the hose loops
provided along the frames.
3-14
through 3-24. Route the
CAUTION
NOTE
Hydraulic fold cylinders will have a black restricted fitting
installed in the rod-end only of each fold cylinder. Wrap
the two ends of the fold hoses with a yellow hose wrap.
4. For optional hydraulic disc gang adjustment – Install
the gang adjustment cylinder fittings and hoses as
shown in Figures 3-25
hoses along the right side of the hitch, and through
the hose loops provided along the frames.
NOTE
Only one black restricted fitting will be installed in the rod
end of the left wing disc gang cylinder. Wrap the two ends
of the gang adjustment cylinders with a black hose wrap.
For optional hydraulic disc gang adjustment – Install the
depth indicator on the right front center frame disc gang.
through 3-27. Route the
F-756-0321