Comtech EF Data XTD-750C-B1 Operation And Installation Manual page 81

Firmware Update Procedure, HPA
Overview
Required Items
MNC-0500-014
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
This document applies to HPAs with Rabbit Based
Microprocessors.
This chapter provides the service technician with information
and a procedure that will allow the equipment firmware to be
updated. Contact Customer Service for assistance. Contact
information is located in the chapter titled Overview.
The following files, listed by part description, are required to
operate your equipment. The specific part numbers, 800-XXXX-
XXX, 803-XXXX-XXX, 807-XXXX-XXX, and 808-XXXX-XXX are
listed in the appendix titled Firmware.
The middle four digits (XXXX) of the 803 correspond to the
middle four digits (XXXX) of the 808 part number.
800-XXXX-XXX
•
Bill of material for the files required to operate your equipment.
The last three digits (XXX) match the last three digits (XXX) of the 807-XXXX-
XXX
Part Number 803-XXXX-XXX consists of the set of support files
•
listed below:
coldload.bin
pilot.bin
flash.ini
Rfu.exe
Part Number 807-XXXX-XXX is the model configuration file. This is
•
a text file that is loaded at the factory to configure the HPA to a
predefined option.
Part Number 808-XXXX-XXX is the firmware executable for your
•
equipment.
The following equipment is required to perform this procedure:
PC (Personal Computer) — laptop or desktop with a serial port.
•
A NULL modem cable.
•
3 of 6
Firmware Update Procedure, HPA
Note
Revision B