Table of Contents
Advertisement
Service and Maintenance
7.5 Hydraulic Oil
Check hydraulic oil level every 50 hours.
The hydraulic tank on power pack is located opposite the engine
beside the trailer tongue. It has a cap / dipstick that indicates the
level of oil in the tank.
The quality of the oil should be inspected every 50 hours. If the
oil is dirty or smells burnt, it should be replaced.
When checking the oil level–
1. Make sure the machine is in safe condition to work on. See
page 7.
2. Allow the engine and muffler to cool.
3. Clean area around fill cap and remove cap.
4. Using a clean funnel, fill the tank according to the oil dip stick:
• Never fill the oil tank above the full (F) line at the top of
the dip stick.
• Do not run the machine with the oil level below the
bottom (L) line at the bottom of the dip stick.
• Reservoir capacity is 4.6 US gal (17.5 L).
• Use Dexron® III ATF for all operating conditions.
Dexron VI or Mercon® are acceptable substitutes.
• Install fill cap securely and wipe up any spilled fuel.
Check levels after changing filters or servicing hydraulic
components.
F
L
Fig. 56 – Hydraulic Oil Level Check
7.5.1 Hydraulic Oil, Changing
The drain plug is located at the bottom of the hydraulic tank.
Allow the machine to cool before changing the oil. Hot oil can
cause burns if it contacts exposed skin. It is best to change
oil while the machine is warm to keep the contaminants in
suspension.
1. Make sure the machine is in safe condition to work on. See
page 7.
2. Have a drain pan ready of the correct capacity.
3. Clean area around drain and remove the plug.
4. Allow the oil to drain, then flush the tank.
5. Install the plug and refill the tank with oil.
6. Dispose of used oil in an environmentally acceptable
manner.
01689
52
Fig. 57 – Hydraulic Tank Drain plug
LXT95 / LXT115
Log Trailer & Grapple
01691
Advertisement
Table of Contents
