Table of Contents
Advertisement
Safety
7. Caution!
Hydraulic fluid under pressure. In the
event of a leak, shut machine down. Do
not check for leaks with bare hands. Wear
proper hand and eye protection when
searching for a high-pressure hydraulic
leak.
2.17 Information Decals
Tie Down Point
This decal indicates a tie-down point
on the trailer frame.
Recommended Speed Limit
This decal indicates the
maximum recommended
highway speed of
50 mph (80 km/h) for
this trailer.
IMPORTANT! If parts are replaced that have safety signs on
them, new signs must be applied. Safety signs must always
be replaced if they become damaged, are removed, or
become illegible.
Safety signs are included in the product decal kit available from
your authorized dealer. Decals are not available separately.
2.18 Replacing Damaged Safety Signs
• Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or the factory.
• Keep safety signs clean and legible at all times.
• Parts replaced that had a safety decal on them must also
have the safety sign replaced.
Procedure
Installation area must be clean and dry. Make sure the surface is
free of grease or oil. Ambient temperature must be above 50 °F
(10 °C).
Determine exact position before removing the
backing paper on the decal.
1. Peel the decal off the backing sheet.
2. Align the decal with an edge on the machine if possible.
3. Starting on one edge, carefully press the center of the
exposed sticky backing in place, smoothing it out as you
work from one side to the other.
4. Use a squeegee, credit card or similar to smooth it out.
Work from one end of the decal to the other end.
Small air pockets can be pierced with a pin and smoothed out
using the piece of sign backing paper.
18
LXT95 / LXT115
Log Trailer & Grapple
Advertisement
Table of Contents
