Table of Contents
Advertisement
IMPORTANT
Prodigy 2.0 is not compatible with Prodigy 1.0. Do not
implement the two protocol versions within the same network.
If you are expanding an existing network using new Fluidmesh
hardware components, make sure that all components are
compatible with each other by:
Option 2 is recommended if the network does not contain older
Fluidmesh devices that are not compatible with Prodigy 2.0.
If needed, change the unit's Prodigy version by clicking the Prodigy 1.0
radio button or Prodigy 2.0 radio button.
Save the Prodigy version settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.
Changing the LAN parameters
The LAN Parameters box (below) contains the entry controls for local-
address setting.
NOTE
When the General Mode window is opened for the first time,
the Local IP and Local Netmask LAN parameters will be
factory-set default values.
The information needed is self-explanatory. To enter a parameter, click the
field and type the parameter.
If needed, enter the local primary DNS address in the Dns 1 field, and
enter the local secondary DNS address in the Dns 2 field.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
1. Upgrading all network components within the same
network to firmware version 6.5 or higher.
2. Configuring all network components within the same
network to operate using either Prodigy 1.0 or Prodigy
2.0.
Page 66 of 174
Advertisement
Table of Contents
