Using Snmp V2C - Cisco FM4200 Installation And Configuration Manual

To change the SNMP settings, do the following steps:
• Click the -snmp mode link under ADVANCED SETTINGS in the
left-hand settings menu.
• The default SNMP dialog will be shown
117)).
Figure 44. SNMP dialog (SNMP disabled)

Using SNMP v2c

To change the unit's SNMP mode to v2c and configure the unit
accordingly, do the following steps:
1. Click the
• The SNMP v2c settings dialog will be shown
(page
Figure 45. SNMP dialog (v2c selected)
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
By default, Cisco units are shipped from the
factory with SNMP disabled.
SNMP mode drop-down, and click the v2c option.
117)).
(Figure 44 (page
(Figure 45
Page 117 of 189