Table of Contents
Advertisement
Embedded Terminals with Profibus DP
Master
That results in the greatest absolute value of 30.2 V as upper voltage limit. The
lowest absolute value of 18.5 V is the lower voltage limit.
24 V DC cabling
2
24 V
A
2
0 V
6 mm ² (blue)
A
1
10 mm (green/yellow)
B
①
Easy to remove and visible
②
Cable length between +24 V power sup-
ply unit and the VEP is 6 m max. at a
minimum cross-section of 0.75 mm
ble length between +24 V power supply
unit and the VEP is 10 m max. at a mini-
Fig. 10-8: Wiring the Embedded Terminal
11 Commissioning
The product can be used directly. No configuration is required.
To commission the device, proceed as follows:
During the first commissioning, the configuration applications "Touch calibra-
tion" and the "Rexroth settings" start automatically. They are described in the
project planning manual "Rexroth IndraControl V Devices Operating Systems" (see
tab. 1-1 "Related documents" on page
tings are already done ex works.
DOK-CONTRL -VEP*XX.5***-IT01-EN-P
Overvoltage category I
2
2
. Ca-
mum cross-section of 1.5 mm
tional power supply unit is required if
the length exceeds 10 m.
A
Insulated terminal block
B
Non-insulated terminal block
FE Functional earth
2). For newly delivered devices, these set-
Bosch Rexroth AG
Commissioning
2
XS1
1
VEP
FE
2
. An addi-
25/41
Advertisement
Table of Contents
