Table of Contents
Advertisement
LevelOne 22Mbps Wireless AP Router User Guide
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. The example screen is shown
below.
Data - LAN Screen
TCP/IP
IP Address
Subnet Mask
DHCP Server
Buttons
Save
Figure 6: LAN Screen
IP address for the LevelOne 22Mbps Wireless AP Router, as seen from
the local LAN. Use the default value unless the address is already in
use or your LAN is using a different IP address range. In the latter
case, enter an unused IP Address from within the range used by your
LAN.
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the LevelOne 22Mbps Wireless AP Router is at-
tached (the same value as the PCs on that LAN segment).
•
If Enabled, the LevelOne 22Mbps Wireless AP Router will allo-
cate IP Addresses to PCs (DHCP clients) on your LAN when they
start up. The default (and recommended) value is Enabled.
•
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-configured to
treat the LevelOne 22Mbps Wireless AP Router as the default
Gateway. See the following section for further details.
•
The Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
See the following section for further details on using DHCP.
Save the data on screen.
14
Advertisement
Table of Contents
