Table of Contents
Advertisement
Options
This screen allows advanced users to enter or change a number of settings. For normal opera-
tion, there is no need to use this screen or change any settings.
An example Options screen is shown below.
Data - Options Screen
Backup DNS
IP Address
TFTP
Enable Firm-
ware Upgrade
using TFTP
UPnP
Enable UPnP
Services
Allow Configu-
ration...
Figure 35: Options Screen
Enter the IP Address of the DNS (Domain Name Servers) here. These
DNS will be used only if the primary DNS is unavailable.
•
If enabled, TFTP (Trivial FTP) can be used to upgrade the firm-
ware in this device. This is normally not required; a Windows
utility is available for this purpose.
•
You must obtain the firmware upgrade file first; instructions for
using TFTP will be available with the upgrade.
•
UPnP (Universal Plug and Play) allows automatic discovery and
configuration of equipment attached to your LAN. UPnP is by
supported by Windows ME, XP, or later.
•
If Enabled, this device will be visible via UPnP.
•
If Disabled, this device will not be visible via UPnP.
•
If checked, then UPnP users can change the configuration.
•
If Disabled, UPnP users can only view the configuration. But
currently, this restriction only applies to users running Windows
XP, who access the Properties via UPnP. (e.g. Right - click the
LevelOne 22Mbps Wireless AP Router in My Network Places, and
select Properties)
Advanced Configuration
57
Advertisement
Table of Contents
