Table of Contents
Advertisement
Rear Panel
Reset Button
WAN port
(10/100BaseT)
10/100BaseT
LAN connections
Power port
Figure 3: Rear Panel
This button has two (2) functions:
•
Reboot. When pressed and released, the LevelOne 22Mbps
Wireless AP Router will reboot (restart).
•
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The LevelOne 22Mbps Wireless AP
Router is now using the factory default values.
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note: Any port will automatically function as an "Uplink" port when
required. You can connect any port to a standard port on another hub,
using a standard cable.
Connect the supplied power adapter here.
Introduction
5
Advertisement
Table of Contents
