LevelOne WBR-2400TX User Manual page 10

For best Wireless reception and performance, the Access
Point should be positioned in a central location with mini-
mum obstructions between the Access Point and the PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the LevelOne
22Mbps Wireless AP Router. Both 10BaseT and 100BaseT connections can be used si-
multaneously.
Note: Any port will automatically function as an "Uplink" port when required. You can
connect any port to a standard port on another hub, using a standard cable.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne 22Mbps Wireless
AP Router. Use the cable supplied with your DSL/Cable modem. If no cable was supplied,
use a standard cable.
4. Power Up
•
Power on the Cable or DSL modem.
•
Connect the supplied power adapter to the LevelOne 22Mbps Wireless AP Router and
power up.
Use only the power adapter provided. Using a different one may cause hardware damage
5. Check the LEDs
•
The Power LED should be ON.
•
The Status LED should flash, then turn OFF. If it stays on, there is a hardware error.
•
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
•
The WAN LED should be ON.
•
The WLAN LED should be ON
For more information, refer to the Front Panel section in Chapter 1.
Installation
7