LevelOne WBR-2400TX User Manual page 64

Data - Routing Screen
RIP
Enable RIP
Static Routing
Static Routing
Table Entries
Properties
Buttons
Save
Figure 37: Routing Screen
Check this to enable the RIP (Routing Information Protocol) feature
of the LevelOne 22Mbps Wireless AP Router.
The LevelOne 22Mbps Wireless AP Router supports RIP 1 only.
This list shows all entries in the Routing Table.
•
The "Properties" area shows details of the selected item in the
list.
•
Change any the properties as required, then click the "Update"
button to save the changes to the selected entry.
•
Destination Network - The network address of the remote LAN
segment. For standard class "C" LANs, the network address is
the first 3 fields of the Destination IP Address. The 4th (last)
field can be left at 0.
•
Network Mask - The Network Mask for the remote LAN
segment. For class "C" networks, the default mask is
255.255.255.0
•
Gateway IP Address - The IP Address of the Gateway or
Router which the LevelOne 22Mbps Wireless AP Router must
use to communicate with the destination above. (NOT the router
attached to the remote segment.)
•
Metric - The number of "hops" (routers) to pass through to
reach the remote LAN segment. The shortest path will be used.
The default value is 1.
Save the RIP setting. This has no effect on the Static Routing Table.
Advanced Configuration
61