Exhaust Requirements; Electrical Requirements - Labconco Protector 3410000 User Manual

Exhaust Requirements

As stated earlier, the exhaust discharge of the station, located on the
upper left side on the back of the station should never be obstructed. The
station is designed to have its back surface pushed against a wall, but the
top of the station should have no obstructions within 6 inches of the
exhaust discharge.

Electrical Requirements

The Downdraft Station models have the following electrical requirements:
Model #
3410000-01
3410020-25
Note: An outlet with a circuit breaker rated at 10 amps for 115 volt
models (5 amps for 230 volt models) should be located as close as
possible to the right rear side of the station. Power cords supplied
with the station are 3 meters (10 feet) long.
Product Service 1-800-522-7658
Chapter 2: Prerequisites
Table 2-1
Requirements
115 VAC, 60 Hz, 1 Amp
230 VAC, 50/60 Hz, 0.5 Amp
3