Table of Contents
Advertisement
Chapter 3: Getting Started
3) Install both side shields by engaging the notches in each panel into the
gap between the front panel and the filter module. Ensure the side panel
pin engages the oversized holes on the edges of the work surface.
Ensure the pins
go into the
oversized
holes.
4) Plug the power cord into the filter module. The plug socket is located on
the top right rear corner of the station. The unit is ready for use.
6
Figure 3-3
Product Service 1-800-522-7658
Advertisement
Table of Contents
Need help?
Do you have a question about the Protector 3410000 and is the answer not in the manual?
Questions and answers