Miele H806 Series Technical Information page 18

Technical Information
Figure 2-3: Installation Overview
1. Connect the oven to the mains electrical supply.
2. Push the appliance into its recess so that the steam deflector strips
rest against the housing unit and align. It is important that the housing
unit has a recessed rear panel to provide a vent duct at least 100 mm
deep.
3. Use 4 screws; refer to Figure 2-3, to anchor the appliance in the
housing unit:
- 2 screws under the fascia panel;
- 2 screws behind the door of the lower cavity
To access the screws, remove the lower door as described in Section
2.1.1.
H806 Series – Mechanical Oven
18