Thermostat; Removal; Removal Of Components - Miele H806 Series Technical Information

Technical Information
5.7

Thermostat

5.7.1

Removal

1. Remove the appliance from its housing unit and take off the rear
panel.
2. Remove the sensor bracket and then remove the sensor from its
pocket.
Note:
When fitting a thermostat sensor, care should be taken to insert the
sensor into the correct pocket – refer to Section 5.2. Coding loops in the
capillary tube near the sensor are used to identify the sensors.
Control thermostat:
Safety thermostat:
Automatic roasting thermostat:
5.8

Removal of Components

1. Remove the appliance from the housing unit – refer to Section 5.1.
2. Remove the rear panel to gain access to components.
Note:
The domed nut holding the fan blades has counterclockwise thread.
H806 Series – Mechanical Oven
No loops
One loops
Two loops
40