D2 Wash Cycles; D2.1 Table Of Times; D3 Operation - Insinger CADET Technical Manual

The word "FILL" is shown on the display during the
entire filling and heating stage
Notice, this dishwasher does the first tank filling through
several consecutive hot rinse cycles, while the display
shows the message FILL (scrolling across display). This
system save up to 30% in time over traditional models. If
the door is opened during this stage the message
"CLOSE" will scroll on the display:
The filling and heating stage has finished when the
display shows the tank temperature:
To display the boiler temperature during heating of the
tank, open the door and press "G" button (Figure 14).
D2 WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (150°F [66°C] min) and one rinse with hot
water and rinse-aid (180°F [82°C] min).

D2.1 Table of times

Standard cycle time with supply water at 122°F [50°C].
120
sec.
A device lengthens the cycle time if the water in the
booster has not reached the minimum temperature for
correct rinsing.
The cycle times and the temperature may be persona-
lized (e.g. increase of the rinse time and temperature).
The cycle times should only be set by an Authorized
Service technician.
D3 OPERATION
The filling and heating stage has finished when the dis-
play shows the tank temperature:
14


240 130
sec. sec.
The appliance is then ready for use:
• Open the door.
• Insert the rack containing the dirty dishes.
Close the door and select the suitable wash cycle; the
corresponding indicator light comes on and the wash
cycle starts:
- Cycle I
For lightly soiled dishes or glasses: press "G" button
(Figure 14) (see table of times).
- Cycle II (recommended)
For normally dirty dishes: press "H" button (Figure 14)
(see table of times).
- Cycle III Specific cycle for glasses
To stop the wash cycle, just press the selected cycle
button or open the door.
• To continue the wash cycle, just press the selected
cycle button or close the door. The cycle starts again
from where it stopped.
• At the end of the wash, the dishwasher emits a series of
beeps and "END" blinks on the display:
open the door and remove the rack containing the
clean dishes.
WARNING
The appliance will not remove burnt food deposits
from dishes. Dishes with burnt-on food deposits
should be cleaned manually using detergent (for
example, prewash under running water) before put-
ting them in the dishwasher
Change the water in the tank at least twice a day.
