Installing The Light Kit - HAMPTON BAY SEAPORT AL634-WH Use And Care Manual

Assembly — Installing the Light Kit
Installing the light kit mounting
11
plate
□
Remove the 1 of 3 mounting ring screws (JJ) from the
mounting ring and loosen the other 2 screws. (Do not
remove)
□
Place the key holes on the light kit mounting plate (I)
over the 2 mounting ring screws (JJ) previously
loosened, turn the light kit mounting plate(I) until the
light kit mounting plate (I) locks in place at the
narrow section of the key holes. Secure by tightening
the 2 mounting ring screws (JJ) previously loosened
and the one previously removed.
12
□
Remove the 1 of 3 light kit mounting screws (KK)
from the posts of the light kit mounting plate (I) and
keep it for future use. Loosen the other 2 screws. (Do
not remove)
□
While holding the light kit (J) under your fan motor
assembly (F), snap together the 9 pin connection
plugs. one from the fan motor assembly (F), and one
from the Light kit (J).
□
Place the key holes on the light kit (J) over the 2 light
F
kit mounting screws (KK) previously loosened from
the mounting ring, turn he light kit (J) until he light kit
(J) locks in place at the narrow section of the key
holes. Secure by tightening the 2 light kit mounting
screws (KK) previously loosened and the one
previously removed.
I
JJ
14
Mounting the light kit to the
light kit mounting plate
CAUTION: Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
F
I
J
KK