Table of Contents
Advertisement
Assembly
1
Preparing the canopy
□
Remove the canopy bottom cover (C) from the canopy
(B) by turning the canopy bottom cover (C) counter-
clockwise.
□
Remove the mounting bracket (A) from the canopy (B)
by removing the non-slotted canopy mounting screw
(EE) from the bottom of the canopy (B) and loosening
the slotted canopy mounting screw (EE) a half turn
from the screw head. Next, turn the canopy (B)
counterclockwise to removing the mounting bracket
(A) from the canopy (B).
EE
3
Assembling the fan
□
Route the wires exiting from the top of the fan motor
assembly (F) through the coupling cover (E) and the
canopy bottom cover (C). Make sure the slot
openings are on top. Route the wires through the
canopy (B) and then through the hanger ball/downrod
assembly (D).
□
Align the holes at the bottom of the hanger
ball/downrod assembly (D) with the holes in the collar
on top of the fan motor assembly (F). Carefully insert
the clevis pin (FF) through the holes in the collar and
the hanger ball/ downrod assembly (B). Be careful
not to jam the clevis pin (GG) against the wiring inside
the hanger ball/ downrod assembly (D). Insert the
cotter pin (GG) through the hole near the end of the
clevis pin (FF) until it snaps into the locked position.
□
Tighten two collar set screws (HH) on top of the fan
motor assembly (F) firmly.
WARNING:
Failure to properly install the cotter pin (GG)
could result in the fan loosening and possibly falling.
2
A
EE
B
C
9
Preparing the motor
□
Remove the clevis pin (FF), cotter pin (GG), and
loosen the 2 collar set screws (HH) from the motor
collar.
HH
C
E
GG
HH
F
NOTE: If a longer downrod is needed, take out the screw
located in the hanger ball, lower the hanger ball and remove
the pin, remove all 3 pieces from the downrod and assemble
them onto the new longer downrod before proceeding
downrod intallation. (The longer downrod is available at any
Home Depot store)
Please contact 1-877-527-0313 for further assistance.
GG
HH
FF
D
B
FF
HAMPTONBAY.COM
Advertisement
Table of Contents
