Installing The Light Kit - HAMPTON BAY GLENDALE AG524I-BN Use And Care Manual

Assembly — Installing the Light Kit
Attaching the Light Kit to
11
the Switch Housing
CAUTION: Before starting the installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
□
Remove the three light kit mounting screws (JJ) from
the light kit (H) and keep these screws.
□
While holding the light kit (H) under your fan motor
assembly (E), locate two single white and blue wires
in the switch housing labeled "FOR LIGHT". Make the
polarized plug connections:
- White to white
- Blue to black
□
Carefully push all wires back into the switch housing.
Install the light kit (H) onto the switch housing with
the three light kit mounting screws (JJ) provided. Be
sure to tighten all screws.
E
JJ
Mounting the Glass Shades
12
and Installing the Light Bulbs
□
Mount the glass shades (I) to the light sockets by
partially unscrewing the three light holder
thumbscrews (CC) on each glass holder, inserting the
glass shades (I), and gently and evenly tightening the
light holder thumbscrews (CC) by hand to the glass
shades (I). Do not overtighten.
□
Install three 9.5-watt LED bulbs (J) (included).
CC
H
15
I
J