Advertisement
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or
removing the fuse at fuse box.
1. While holding the light kit assembly under your
fan, snap together the wire connection plugs .
2. Carefully push all wires back into the switch
housing, then install the light kit assembly onto the
mounting plate with 3 screws provided. Be sure to
tighten all screws. (Fig.15)
3. Install 3 x 40W candelabra bulbs (not included).
4. Remove the metal nut, glass cap and decorative
nut from the light kit. Raise the glass shade up
against the light kit, Place the metal nut on the top
over the stem and turn it clockwise until it locks up
against the glass shade. Do not overtighten. (Fig. 16)
5. Raise the glass cap and decorative nut against the
glass shade and secure it to the stem by turning the
decorative nut clockwise until snug. Do not
overtighten. (Fig. 16)
Connection plugs
Light kit
assembly
Figure 15
Installing the Light Kit 8.
Screws
Metal nut
Glass cap
Decorative nut
Figure 16
Bulbs
Glass
shade
Advertisement
