Table of Contents
Advertisement
7
Power button
8
Reset hole
9
Reserve port
10
Power supply module
User Guide
No light indicates "no power" or
"no connection" to the ExaSAN
storage.
Fail LED (bottom):
Solid Red indicates the port is
connected to a client (wrong
connection type).
No light indicates "no power" or "no
error".
Control the power to the SWF16
Push the button to turn on the
power to SWF16.
Push the button to turn off the
power of SWF16 and shut down
automatically.
Push the button for 5 seconds to
shut down the power of SWF16
Immediately.
If you want to master reset all settings of
the SW16, you could use a needle or pin
to push the rest button in the hole for 13
seconds. Then you'll hear two short beeps
and the SW16 will restart. All settings
would go back to default.
Caution:
If you push reset button in the hole but
are still connected to clients, you may
damage important data in the SAN.
This QSFP port is reserved.
Connects to independent power sources
for fault tolerance.
1. Introduction
Page 1-14
Advertisement
Table of Contents
