Table of Contents
Advertisement
Important
• When the BUSY LED is lit or blinking, do not turn off the basic processing unit. This may cause
a malfunction or damage data.
• To avoid malfunction, do not transport this unit with the data cartridge installed.
LED indication
Three LED on the External AIT's front side signal the status of the drive and the AIT data
cartridge.
LED name
Indication status
BUSY LED
OFF
ON
Blink
TAPE LED
OFF
ON
Blink (at a given interval)
Blink (repeating a long ON
and a short ON)
STATUS LED OFF
ON
Blink (repeating a long ON
and a short OFF)
Blink (at a given interval)
Blink (repeating a short ON
(once or twice) and a long ON)
Reading/writing data
To read/write the data from/to the AIT data cartridge, see the instruction manual provided with the
backup application.
Description
–
Transmitting or receiving the data now
The data is normally read/written from/to the
data cartridge set in the External AIT.
The data cartridge is not set.
The data cartridge is set.
The data cartridge is being set or ejected.
The data cartridge set in the External AIT is
deteriorated.
The data cartridge set in the External AIT is
ready to write data.
The data cartridge set in the External AIT is
not enabled to write data (write-protected).
The External AIT head needs cleaning.
During the head cleaning, the cleaning
cartridge tape comes to the end.
The drive is broken.
External AIT 75
Advertisement
Chapters
Table of Contents
