Section 2: Framing; In Wall And Corner Dimensions; Alcove Above The Fireplace - Montigo DelRay DRL3613NI-2 Installation & Maintenance Manual

Section 2: Framing

In Wall and corner Dimensions

1). Frame in the enclosure for the unit with framing materials. the
framed opening for the assembled fireplace shown below in table
NOTE: When constructing the framed opening, please ensure there is
access to install the gas line when the unit is installed
856
11
34"
33 16 "
362
1
14 4 "
DRL*3613 DIMENSIONS
A B c
433/8 671/8 471/2
Figure 3.a Framing dimensions table
12.700
1
* When sheetrock is used behind the fireplace, framing depth may be 2 "
increased by 1/2".
12.700
1
2 "
1206
c
1
47 2 "
Figure 3.b Framing dimensions (Straight wall & Corner Installation).
8
Framing header must
be turned on edge to
meet vent clearance
1101.100
3
A
43 8 "
DRL*4813 DIMENSIONS
A B
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 553/8 1/32" 791/4 Drawn by
TWO PLACE DECIMAL .015"
THREE PLACE DECIMAL .005" Revision / Date
ANGULAR .5
Revision
ALL BENDS ARE ASSUMED
TO BE 90 UNLESS NOTED
Finish
OTHERWISE.
1101.100
3
A
43 8 "
1705
b 1
67 8 "
DIMENSIONS ARE IN INCHES
TOLERANCES:
Alcove above the fireplace
Figure 3.d Non-combustible Framing for shelves over the fireplace
when this appliance is installed directly on AnY combustible other
than wood flooring (carpet, vinyl, etc.). It must be installed on an
equivalent wood or metal panel. this material must extend the full
c
NAME DATE Description
MNR36 Framing Assembly
DM 31/07/2018
561/16
DWG. NO. MNR36 Framing Assembly
MATERIAL
SCALE 1:32 WEIGHT: SHEET 1 OF 3
clearances must be in accordance with local installation codes and
NAME DATE Description
Installation
Ceiling Level
Non-combustible
materials. Alcove
over fireplace
1" Min.
Non-Combustible
header
10"
Door
Opening
Floor
Warning
width and depth of the appliance.
notice
the requirements of the gas supplier
12"
xg0226 - 042220