Montigo BF52-ST Installation, Operation & Maintenance Manual
Montigo BF52-ST Installation, Operation & Maintenance Manual

Montigo BF52-ST Installation, Operation & Maintenance Manual

Bf-series st gas fireplace

Advertisement

BF-Series ST Gas Fireplace
BF84-ST Shown
Warning:
Improper installation, adjustment, alteration, service or maintenance can cause
injury or property damage. Refer to this manual. For assistance or additional
information consult a qualified installer, service agency or the gas supplier.

Safety Notice:

Glass doors on gas fireplaces are extremely hot while the fireplace is on and remain
hot even after the fireplace has been turned off. Safety screens are available and
can reduce the risks of severe burns.

For Your Safety:

Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
XG0711
Canadian Heating Products Inc. Langley, BC V4W 4A
Installation Operation & Maintenance Manual
Check local codes and read all instructions prior to installation.
®
C
US
f i r e f e a t u r e
www.montigo.com
What to do if you smell gas
Do not try to light any appliance.
Do not touch any electrical
switch; do not use any phone in
your building.
Immediately call your gas
supplier from a neighbor's
phone. Follow the gas supplier's
instructions.
If you cannot reach your gas
supplier, call the fire department.
Montigo Del Ray Corp. Ferndale, WA 98248
BF52-ST
BFL52-ST
BF60-ST
BF84-ST
Warning:
Installer: Leave this manual
with the appliance.
Consumer: Leave this
manual for future reference.
022410

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BF52-ST and is the answer not in the manual?

Questions and answers

Summary of Contents for Montigo BF52-ST

  • Page 1: Safety Notice

    • Installer: Leave this manual with the appliance. ® • Consumer: Leave this manual for future reference. XG0711 Canadian Heating Products Inc. Langley, BC V4W 4A Montigo Del Ray Corp. Ferndale, WA 98248 022410...
  • Page 2: Table Of Contents

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Warning: Read this manual before installing, operating or troubleshooting this appliance. Please retain this owner's manual for future reference. Congratulations Congratulations on selecting a FireFeature Custom gas fireplace, This owner's manual should be retained for future reference.
  • Page 3: Introduction

    Kilowatts) Input. Warranty and Installation Information: Warranty and Installation Information: The Montigo warranty will be voided by, and Montigo disclaims any responsibility for, the following actions: The Montigo warranty will be voided by, and Montigo disclaims any responsibility for, the following actions: Modification of the fireplace and/or components including vent ...
  • Page 4: Installing And Framing The Fireplace

    Cold air has the tendency to settle to the lowest point in the vent system. For extra long air supply runs, Montigo will recommend an increase in vent diameter. When changing the air supply from several incoming air connections to one vent, consult this information with your contact at Montigo.
  • Page 5: Installing The Gasline

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Installing The Gas Line The gas line must be installed before finishing the BF-ST Fireplace. Natural Gas requires a minimum inlet gas supply pressure of 5.5" W.C.
  • Page 6: Installation Requirements

    Use only certified B-Vent vent components. (Use of other parts  will void the Montigo warranty, and may impede the operation of Figure 7. Electrical Supply the fireplace). All joints must be secured as per the instructions provided by the ...
  • Page 7: Power Vent Control Box

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Power Vent Power Vent Control Box Termination Wiring requirements for Power Vent Installation 12” 12” B-Vent Duct, One run for Horizontal or Vertica Installation Required Power Vent Termination Figure 7b.
  • Page 8: Start-Up Sequence Schematic

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Startup Sequence: 1. Ensure that there is continuous power to the Post Supply chamber in the firebox, and it is normally closed unless Purge Control Module. inadequate combustion air supply will open the switch.
  • Page 9: Removing & Reinstall The Door

    Door-window frame are held in place by fine-thread 10-24 screws. Follow the process below to remove, or install the items described. Figure 14. The Fireplace as it is received from Montigo. Figure 15. (Step 2) Remove the Door-window trim by grasping the metal firmly and pull it free it from the frame.
  • Page 10: Installing The Bf52 Logset

    Reference, the final location for Logs Installing the Logs: "E" (Ovals, broken lines). The BF52-ST fireplace is supplied with nine ceramic fibre logs. Un- 2” pack the logs and handle them very carefully. Note: Utilize the front Logrest stiles as reference. (Reference lines indicating centre line orientation, and flush end alignment).
  • Page 11: Installing The Bf60 Logset

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Installing the BF60 Log Set Step 3. Place the Log Labeled "B" in the Diagonal position as shown. Align both ends on-center with the Third Tine, (Front & Back). Installing the Logs: The BF60-ST fireplace is supplied with (9) nine ceramic fibre logs.
  • Page 12 BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Log C Log C Log D Log A Log D Log D Figure. 11m measure Figure. 11n Press Figure. 11o Log Nail, (2- lower end of both Logs pcs) top end of both Logs 1 1/2”...
  • Page 13: Installing The Bf84 Logset

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Installing the BF84 Log Set Step 5. Place the one (1) Log labeled "C" . Align with the grate tines as shown. Note location and direction of Log "D" oval alignment Installing the Logs: cutouts.
  • Page 14: Installing The Bfl52 Designer Beads

    They are attrative yet designed to withstand a high temperature environment such as inside a gas fireplace. These may be spaced at random, or in a visual pattern of your preference. See the Montigo web site for photographs and ideas. www.montigo.com Page 14...
  • Page 15: Facing

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Installation Fireplace Facing (Without Door, BF52-ST (30")) When selecting the finish material for your fireplace, it is important to remember the following: The face of the fireplace may be painted to match the room decor, provided you use a heat-resistant paint.
  • Page 16: Operation

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Operation - Model BF-ST with Honeywell Electronic Ignition For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
  • Page 17 BF-Series-ST Gas Fireplace f i r e f e a t u r e Operation - Model BF-ST-A with American Flame Electronic Ignition For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
  • Page 18: Maintenance

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Maintenance Gas Control Valve WARNING! Do not attempt to clean glass when hot. L42DF-ST Do not clean glass with abrasive materials as any glass etching may cause premature glass failure. Connector Do not operate this fireplace without the glass door, or with a GasC ontrol...
  • Page 19: Warranty

    The duration of any implied warranty with respect to this Montigo Gas Appliance is limited to the duration of the foregoing warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above may not apply to you.
  • Page 20: A State Of Massachusetts / Amendment

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Appendix B - State of Massachusetts Amendment (Gas Fireplace / Equipment sold in the State of Massachusetts) 5.08: Modifications to NFPA-54, Chapter 10 (1) Revise NFPA-54 section 10.5.4.2 by adding a second exception as follows: Existing chimneys shall be permitted to have their use continued when a gas conversion burner is installed, and shall be equipped with a manually reset device that will automatically shut off the gas to the burner in the event of a sustained back-draft (2) Revise 10.8.3 by...
  • Page 21: Notes

    BF-Series-ST Gas Fireplace f i r e f e a t u r e Notes Page 21 Part No. XG0711 - 022410...
  • Page 22 XG0711 - 022410 Canadian Heating Products Inc. Montigo Del Ray Corp. Langley, BC V4W 4A1 Ferndale, WA 98248...

This manual is also suitable for:

Bfl52-stBf60-stBf84-st

Table of Contents