Advertisement
Instructions for kit #B 1925
□
a
20. Glue and tape Dormer Sides to the Dormer Front,
lined up on the edges and at the top. Tape Handy Squares
into the assembly to hold the Sides square.
Dormer Side
Handy Square
Lined up on top
Let the glue dry - take off the tape.
□
21. Glue and tape the Dormer to the house, lined up on the inside.
□
22. Cut Dormer Vertical Trim from the "Side Stripwood"
(
3
/
x
7
/
). Cut the Side Trim first, then the Front Trim.
16
16
Leave a gap at the bottom for shingles (2 thicknesses of shin-
gles) so you won't have to cut the shingles to go around the
Trim
Glue and tape the Trim in place.
This Dormer Front had a curve from the moisture of painting. I used a Divider
both to pull the Dormer Front against the Roof, and to hold it straight while the
glue dried. Once the glue was dry 'straight' became permanent.
Dormer Assembly
Prepare flaps of tape
Handy Square
view from the top
page 22
Dormer Side
Lined up on top
Dormer Trim
Advertisement
