Advertisement
Instructions for Kit #B 1925
Everything that you attach to the house assembly from now
on should be fully painted (except for texture paint... that
will be applied during the Porch assembly).
□
11. Glue and Tape the Front Trim
(
) to the Front at both edges.
3
/
32 x 7
/
x 9
16
Temporarily set the Postbases
in approximate position.
Assemble the Porch: These instructions are customized for stucco/texture paint. The Foun-
dation, the Postbases, and the Steps are painted with one coat only of the paint color with
no texture additive, and they are sanded. The Rails, the Post sets, the Arches, and the Porch
Beam are painted with two coats.
Stucco/texture paint is mixed and ready.
Without glue, set up the Porch parts. You may wish to lift the Rails with some shingles.
□
12. Without glue, set the Front Step between the Postbases.
Set the Tread in place up-side-down (to "mask" the place on the
foundation where it will be glued); Texture paint the Foundation
above the Steps - avoid the edge of the Base Floor - Porch Edge
Nosing will attach there after everything else is done (keeping
the texture paint away from an edge is possible because the first-
coat is the same color, so the texture paint only has to approach
the edge).
Now there is texture paint on the Foundation where it will be
visible, and there is no texture paint where the Step or Postbases
will glue.
Clean off the bottom of the Tread.
Do not glue the Step to the Foundation yet.
Clean residual Stucco from the Tread
Front Trim
Railings
PostBase
Front Steps
Temporary use of the Steps to mask
the Foundation for painting.
Foundation behind the Front Steps
Porch Assembly
page 16
Temporary use
of Shingles
Advertisement
