Advertisement
Instructions for kit #B 1925
□
6. Complete all of step 6 without stopping.
A. Spread glue in the grooves of both Sides. Tape the Base Floor to
the Sides, lined up in back (down) the floor sticks out
(up). Make sure the Floor is all the way to the top of the Sides'
grooves.
B. Set the Mid Floor into the grooves lined up in back (the floor sticks
out
1
/
" in front), and with the stairhole closer to the front (up). Hold
8
the Sides tight onto the Mid Floor with a piece of tape above where
the Front will attach (on the sloped part) so the tape won't be
in the way.
C. Glue and tape the Groove-Fill into the exposed groove
within the stairhole.
Step 6B: front edges are up
The Mid Floor sticks out
1/ 8
" in front
□
6 D. Spread glue in the grooves of the Front and on the front edges (up) of the Sides.
(1) Set the Front on the housebody lined up side-to-side at the base corners.
Tape the Front to the housebody along the base.
1
/
" in front
8
Tape
Stair hole is to the Front
Note: if the Groove-Fill is too tight to slip into
the groove, turn the house on its side and use
a hammer and block (Front Step) to tap it in.
Step 6D: Line up the Front side-to-side; tape along the bottom.
Housebody
Step 6A: front edges are up
The Base Floor sticks out
/
" in front
1
8
Step 6C: Groove Fill
The Base Floor is pushed to
the top of the groove
page 12
Base Floor
Advertisement
