Advertisement
Instructions for kit #B 1925
□
27. Pull the bottom hinge pin to disassemble the door
for painting. Tape the pins under the threshold so you
don't lose them (a cut off of a paper clip can substitute
for a lost pin). Re-assemble the door when the painting is
done.
Secure the pane with a tiny dot of glue in each corner.
Trim
Turn the house up-side-down on several thicknesses of cardboard.
□
28A. Porch Rafter Ends: Lightly mark the underside of the
Porch Roof every 2" from right to left, then again from left to
right. This will give you pairs of marks
the Porch Rafter Ends.
Glue the Porch Rafter Ends to the Roof and Porch Beam Cap.
Use the Handy Square to keep them straight.
Arch
□
29. Tape together the Cricket Roofs at the peak.
Lay the Cricket Triangle into the roof set spaced
evenly from the front edges and set back so that the
bottom edge of the Cricket Triangle exactly matches
the bevels on the Cricket Roof edge.
Paint the Cricket Set parts
Glue and tape the Cricket set together.
When the glue is dry, glue the Cricket to the Porch
Roof, lined up on the front edge and centered side-
to-side. See the photo on page 29.
Let the glue dry.
3
/
" apart for locating
16
Porch Rafter End
□
28B. Arches (options are on page 19):
Glue Arches to the Posts and Porch Beam,
centered front-to-back.
Bevel
Cricket Triangle
Spaced evenly
Door, Trim page 25
Porch Rafter End
Cricket Roofs
Lined up with
the bevel
Advertisement
