Encoder Jumper; Figure 5 Encoder Jumper; Table 2 Power Measurement - Infineon CPU-42A-V1 Manual

Hitex PowerScale probe is provided on the CPU_42A-V1 board to measure the power consumption of the
XMC4200.
Table 2 Power Measurement
Jumper Function
JP300 PowerScale
2.2

Encoder Jumper

The jumper JP200 "ENENC#" on the CPU_42A-V1 board is used to enabled/disable an external unit connected
to the ACT satellite connector, e.g.an encoder line receiver on the Motor Drive Card MOT_GPLV-V2.
The signal on the encoder jumper is not connected to the XMC4200. It's connected to pin 30 of the ACT satellite
connector only. If the jumper JP200 is shorted, a ground level is driven at pin 30 of the ACT satellite connector.
If the jumper is open the line is floating. In this case a pull-up resistor on the ACT satellite card must ensure a
high level.
Figure 5 Encoder Jumper
Board User's Manual
Description
A Hitex PowerScale probe can be connected for current sensing the
VDD3.3 (CPU power source). Default: pos. 1-2 (closed)
Note: On the PCB there is a shorting trace between pin 1-2. This trace has
to be cut first, before using PowerScale. Pin 3 is GND.
11
CPU_42A-V1
CPU Board XMC4200 Actuator
Hardware Description
Encoder
Jumper
Jumper.emf
Jumper.emf
Revision 1.0, 2013-02-19