Printing Data - Ricoh L5160 Cip Training

CIP Training L5160/L5130
Basic Operation
The optimal adjustment value is the number above the square pattern that has the faintest
color closest to gray and aligned verticals on both sides. If the value in row "A" is " 2", the
adjustment value of "A" is " 2". We recommend checking the optimal adjustment value by
using a magnifying glass.
13. Select a row from [A] to [W] that needs adjusting. If an item you want to select
is not displayed, press [ ] or [ ] to switch the screen.
14. Enter the adjustment value that you checked in Step 12 using the number keys,
and then press [Set].
15. Press [Completed].
16. Press [Completed].
As required, press [Back] and return to Step 13.
17. Press [End].
• If the control panel is not used for 30 minutes, the adjustment value entry menu is canceled
and the Home screen returns. If this happens, carry out the adjustment procedure again from
the beginning.
• If the print result does not include a square pattern with aligned verticals on both sides, enter
as the adjustment value the number above the closest match to such a pattern. Then, after the
adjustment, manually perform drop position adjustment again.
• Perform the adjustment repeatedly until a square pattern having the faintest and closest color
to gray and aligned verticals on both sides is printed below "0".

Printing Data

Before Print Start
Check the state of the ink cartridges, cleaning cartridge, flushing cartridge, and waste ink bottle
before printing. For details about how to check the conditions, see "Checking Machine Status
and Settings".
For details about replacing consumables, see "Replacing Consumables".
• If the ink cartridge becomes empty during printing or the waste ink bottle is full, printing
will be interrupted. Check the remaining capacity of the ink cartridges and the waste ink
bottle beforehand.
• If you send the RIP data to start printing when the heater is still not warmed up (such as
when the heater is still off), ripples may be produced in the media. Increase the
temperature up to that required for printing. Also, if there are ripples on the media on the
platen or roll feed unit, feed the media using the [Origin Setting] menu, eliminate the
ripples, and then send the RIP data to start printing.