Ricoh L5160 Cip Training page 4

CIP Training L5160/L5130
Basic Operation
Adjusting the Heater Temperature
Set the heater temperature to meet the characteristics of the media. Set the
temperature of the pre-heater, print heater, post-heater, and cure heater
according to the type and characteristics of the media used. Automatic
temperature setting can be made on the operation panel by setting the profile on
the dedicated RIP. For setting on the RIP, see the instruction manual for your RIP.
Do not leave the media with the heater ON for a long time.
This section explains how to check and change the temperature of the pre-heater, print heater,
post-heater, and cure heater.
Set the temperature of each heater depending on the media to be used. It takes several minutes
or hours to reach the configured temperature depending on the operating environment.
1. Check the temperature of each heater on the home screen.
For details about how to check the temperature, see "Checking the state of the heater".
2. Press [Heater Setting].
3. Select the [On] check box when enabling the heater.
Press [All On] or [All Off] to enable or disable the pre-heater, print heater,
post-heater, and cure heater collectively.
4. Press [ ] [ ] to set the temperature of each heater.
(mainly Europe and Asia)
• Press
All +5°C
print heater, post-heater, and cure heater collectively. The temperature of
each heater can be set between 20 to 70°C or 20 to 95°C.
All -5°C] to change the temperature of the pre-heater,