Ricoh L5160 Cip Training page 21

CIP Training L5160/L5130
Basic Operation
4. Press [Cut].
• Start cutting at the cut position that you set.
• When [Base line position on the media guide] is selected, media is fed to the media
cutter position before starting cutting.
5. Press [Set].
• When automatically cutting printed media, the settings in RIP software are required. For
details, see "Changing Printer Settings", RIP Settings Guide.
Performing the Connection Methods
• Never open the center cover or raise the lever during printing. Opening the
cover or raising the lever will abort printing.
This section explains procedures for connection methods to reduce image quality defects such as
black lines and white lines as well as variation in concentration. There are two connection
methods, the connection method for the print heads and the media feed.
When executing print-head alignment, the test pattern for adjustment is printed. Note that the
test pattern cannot be printed on narrow media. When executing print-head alignment, use
media having a width of 297 mm (approx. 11.7 inches) or more.
• Printing the test pattern consumes ink. Perform this function only when necessary.
• Perform no other operations while the test pattern is printing.
• An error will occur and test pattern will not print if:
• There is a misfeed.
• One of the machine's covers is open.
• The machine is performing maintenance operations.
• The machine has run out of ink.
• The machine has run out of media.