Ricoh L5160 Cip Training page 29

CIP Training L5160/L5130
Basic Operation
2. Press [ ].
3. Press [Clogged Nozzle Settings].
4. Press [Auto Nozzle Check].
5. Press [Execute].
The nozzle check pattern is printed, and the clogged nozzle is detected.
6. Press [Confirm].
The clogged nozzle is registered.
7. Press [Nozzle Recovery].
8. Press [On].
The clogged nozzle is compensated with another nozzle. Prints with the compensated nozzle
from the first printing job after these settings are configured.
9. Press [Close].
10. Press [End].
• It is not reflected in the result of the test print even when [Nozzle Recovery] is set to [On].
When checking the print result in which the clogged nozzle is recovered, print the recovery
check pattern by using the RIP software. For details about how to print, see "Functions on
the Main Menu", RIP Settings Guide.
Compensating the Clogged Nozzle Manually
After printing the nozzle check pattern, manually register a clogged nozzle. After
registering a clogged nozzle, make sure to enable [Nozzle Recovery].
1. Perform test printing to print the nozzle check pattern.
For details about test printing, see "Performing Test Printing".
2. Cut the nozzle check pattern.
For details about how to cut media, see "Cutting Media".
3. Check for clogged nozzles based on the printing result of the nozzle check pattern.
For details about how to check the print head, nozzle column, and nozzle number, see "How
to Read the Printing Result ".
4. Press the [Maintenance] key.