Start Printing - Ricoh L5160 Cip Training

CIP Training L5160/L5130
Basic Operation

Start Printing

• Never open the center cover or raise the lever during printing. Opening the
cover or raising the lever will abort printing.
• Keep the center cover closed even when the machine is not printing. If not,
dust can accumulate on the nozzles in the heads.
• When using roll media, rewind the roll media and make sure there is no
warping before printing. Failure to do so may cause defects in image quality.
• As you may not obtain the printing result you want for some printing data or
media types, we recommend performing trial printing beforehand.
• Do not open the cover during printing. Doing so may cause a misfeed.
• If you send the RIP data to start printing when the heater is still not warmed up
(such as when the heater is still off), ripples may be produced in the media.
Increase the temperature up to that required for printing. Also, if there are
ripples on the media on the platen or roll feed unit, feed the media using the
[Origin Setting] menu, eliminate the ripples, and then send the RIP data to start
printing.
1. Set media.
For details, see "Setting Media".
2. Check the heater temperature on the display panel.
3. Press [Heater Setting] to adjust the temperature as required.
For details about adjusting the heater temperature, see "Adjusting the Heater Temperature".
4. Send the RIP data to be printed from a computer.
• When data has been received from a computer, the Data In indicator of the machine
flashes.
• For details about sending RIP data from a computer, see "Functions on the Main Menu",
RIP Settings Guide.
5. Press the [Off Line/On Line] key on the control panel to set the status to online.
"Ready" is displayed on the home screen. Start printing.
DWU105