Ricoh L5160 Cip Training page 16

CIP Training L5160/L5130
Basic Operation
2. Press [Drop Position Adjustment].
3. Press [Auto].
4. Select a print mode from [6 Pass / 8 Pass], [12 Pass], [16 Pass], or [32 Pass].
If the ink configuration used for the machine is 4C+W, you can select [12 Pass (White)].
5. Press [Execute].
The test pattern of the drop position adjustment is printed, and then drop position
adjustment is performed.
6. Press [Confirm].
7. Press [Close] twice.
8. Press [End].
Adjusting the Drop Position Manually
If image quality defects cannot be reduced even after adjusting the drop position automatically
or you want to adjust visually, adjust the drop position manually.
When using transparent or colored media, adjust the drop position manually.
You cannot print a test pattern on narrow media. When adjusting the drop position manually,
use media that has a width of 420 mm (approx. 16.5 inches) or more.
1. Press the [Standard Procedure] key.
2. Press [Drop Position Adjustment].
3. Press [Manual].
4. Select a print mode from [6 Pass / 8 Pass], [12 Pass], [16 Pass], or [32 Pass].
If the ink configuration used for the machine is 4C+W, you can select [12 Pass (White)].
5. Press [Execute].
The test pattern of the drop position adjustment is printed.
According to following steps 6 to 11, cut off the roll media the printed test pattern for
adjusting the drop position. If the paper is not attached to the roll-up unit, Steps 6 to 8 for
cutting the leading edge of the paper are unnecessary.
6. To cut the leading edge of the test pattern for adjusting the drop position, feed the media
by pressing [Feed] or [Rewind].
7. Press [Cut].
The selection screen for the cutting position is displayed.
8. Select [Position of the cutter], and press [Cut].
DWU103