Table of Contents
Advertisement
Chapter 4 PCI Graphic Setup
4.1 Introduction
The POC-S155 has an onboard PCI/AGP flat panel/VGA interface. The
specifications and features are described as follows:.
4.1.1 Chipset
The POC-S155 uses a Intel 855GME/852GM for its graphic controller. It
supports LVDS LCD displays, and CRT monitors.
4.1.2 Display memory
The 855GME chip, the VGA controller can drive CRT displays up to
1600 x 1200 at 85-Hz and 2048 x 1536 at 75-Hz, color panel displays in
LVDS model with resolutions up to UXGA panel resolution with fre-
quency range from 25 MHz to 112 MHz.
The 852GM chip , the VGA controller can drive CRT displays up to 1600
x 1200 at 85-Hz and 1920 x 1440 at 60-Hz, color panel displays in LVDS
model with resolutions up to 1400 X 1050 at 75- Hz.
4.1.3 Display types
CRT and panel displays can be used simultaneously. The POC-S155 can
be set in one of three configurations: CRT only, LVDS only, both CRT
and LFP (LVDS). The system is initially set to simultaneous display
mode - CRT and LFP (LDVS).
.
4.2 Installation of PCI Graphic Driver
Complete the following steps to install the SVGA driver. Follow the
procedures in the flow chart that apply to the operating system that you
are using within your POC-S155.
Important
POC-S155 User Manual
The following windows illustrations are examples only.
You must follow the flow chart instructions and pay
attention to the instructions which appear on your
screen.
20
Advertisement
Table of Contents
