A&D MF-50 Instruction Manual page 37

Store Parameters and Finish the Operation
14. Press the
the measurement program to program number 3.
Pressing the key, the weighing mode is automatically
displayed.
When PROG 3 is recalled, the settings can be used.
To cancel the new parameters and return to the
weighing mode, press the
Timer Mode
This explanation uses the following parameters and sample displays of MX-50.
Ramp time
Common Items
Program number ..........................................4 ( PROG 4 )
Analysis mode ..............................................Timer mode (Symbol: U-t )
Drying program
Measurement unit ..............................................Moisture content
Minimum scale value during measurement ..0.01 %
Minimum scale value of gram display...........0.001 g
Sample quantity............................................Approximately 5 g
Data memory function ..................................Not used
1. Display gram unit (of the weighing mode).
Select a Program Number to Edit the Measurement Program
2. Press the
key to select a program number.
↑
3. Press the
4. The analyzer displays
weighing mode.
Caution If the data memory function is active, the data
memory number (MEM) is displayed in place of the
program number (PROG).
MS-70 / MX-50 / MF-50 / ML-50
key to store the new parameters of
ENTER
RESET
Refer to page 33 for Standard Mode, Automatic Mode or Manual Mode
Final drying temperature
Drying time
Heating pattern....................Ramp drying (
Final drying temperature.....160°C
Ramp time...........................5.0 minutes
Drying time ..........................10.0 minutes
key and press the
PROGRAM
key to use the number.
ENTER
and returns to the
end
key.
or
↓
Program number
35
0. 0 00
160°C
g
Gram display of
weighing mode
)
% MOIST
D /W/D
PROG 1
0. 0 00
PROG " 4
end
PROG 4
0. 0 00
g
g