A&D MF-50 Instruction Manual page 23

11. Open the heater cover. Put in a sample using the
level indicator.
Caution
The sample needs to be more than 0.1 g.
Spread the sample evenly.
12. If the key is pressed during gram display, analysis
↑
mode, measurement unit and minimum scale value
are displayed. If the
sample mass is output.
Start the Measurement
13. Close the heater cover. Press the
after a stable value is displayed.
14. If the
SELECT
other units can be displayed temporarily and its
measurement values can be output.
Caution
Do not press the
sampling data.
Finish the Measurement
15. When the change of moisture content per one
minute (drying rate) reaches the preset termination
value, the measurement is completed and the
buzzer beeps.
16. Open the heater cover and remove the sample
using the pan handle.
17. Press the following key to return to gram display.
key......Outputs (Prints) result.
ENTER
key ....Returns to the weighing mode.
SELECT
key......Returns to the weighing mode and
RESET
18. If the same condition is used, proceed to step 8.
If changing the condition, proceed to step 2.
The sample pans can be washed and reused.
There is the Reference card on the bottom of the analyzer.
MS-70 / MX-50 / MF-50 / ML-50
Range of proper sample
Sample needs more than 0.1 g.
Significant sample is indicated
segment.
key is pressed, the
ENTER
key is pressed during measurement,
key while
SELECT
displays zero.
key
START
Drying temperature
Analysis time
21
No good Good
Drying rate
Result
Remove sample
Close