Furuno FS-1562 Manual page 358

3.5.2 Display on terminal unit
The same items are monitored on both the terminal unit and the handset, with the
exception of the data and time indication. In addition to the system time, the terminal
unit has own time which is displayed at the upper right-hand corner of the terminal
screen. The time is set by using the following its procedure.
System time:
The Real Time Clock (RTC) on the CPU board generates date and time. When time
between RTC and ZDA from a navaid differs more than 30 seconds for 30 seconds or
more, the RTC is reset by using ZDA data. If ZDA is not available, RMC is used. Time
and date displayed on the handset are system time. Furthermore, the communication log
also uses system time.
Terminal unit time:
The file created on the terminal unit is labeled by this time. To preset time and date,
press [F4] [3] [1] and [F4] [3] [2] respectively.
Date
Time
Current Satellite
a
Channel Status
MES Status
Tx
Heading
b
Antenna Bearing
Antenna Azimuth
Antenna Elevation
Position
c
NAV DATA
d
GYRO
System time
2001-01-10
00:00:00(UTC)
POR
SYNC
Ready
OFF
270 DEG
209 DEG
119 DEG
30 DEG
LAT 34:00.00N
LOG 135:00.00E
NMEA
OK
H3-29
(01-01-10 00:00:00)
Tx EIRP Level
e
Tx RF Level
Rx C/N
Rx IF AGC Level
Rx SYN
f
Tx SYN
Antenna Status
g
El AXIS
AZ AXIS
Cross El AXIS
Rx Channel
h
Tx Channnel
FELCOM 82
Terminal unit time
000
000
053
154
OK
OK
REMOTE
OK
OK
OK
11292
10000