Furuno FS-1562 Manual page 202

*USA Channel mode
USA CH:016 < TX SIMP HI >
ENABLE= TX[1] RX[2] UN[3]
TX: Transmission and reception available
RX:Reception only
UN:Transmission and reception prohibited
Rotate CHANNEL knob to select a channel to be set.
Press TX[1], RX[2], or UN[3] key, and [Enter] key
USA CH:001 < TX DUP HI >
TELECOM=SIMP[1] DUP[2]
Select communication mode.
Press SIMP[1] or DUP[2] key, and [Enter] key.
USA CH:001 < TX DUP HI >
TX POWER= HIGH[1] LOW[2]
Select TX power.
Press HIGH[1] or LOW[2] key, and [Enter] key.
To set other USA channels.
Rotate CHANNEL knob to select a channel to be set.
*WX Channel mode
WX CH:001 < RX >
ENABLE= RX[1] UNABLE[2]
ENABLE:WX Reception
UNABLE:WX reception prohibited
Rotate CHANNEL knob to select a channel to be set.
Press ENABLE[1] or UNABLE[2] key, and [Enter] key
depending on channel.
To set other WX channels.
Rotate CHANNEL knob to select a channel to be set.
(From previous page)
*INTL Channel mode
*
INTL CH:016 < TX SIMP HI >
ENABLE= TX[1] RX[2] UN[3]
TX: Transmission and reception available
RX:Reception only
UN:Transmission and reception prohibited
Rotate CHANNEL knob to a select channel to be set.
Press TX[1], RX[2], or UN[3] key, and [Enter] key depending on channel.
INTL CH:001 < TX DUP HI >
TELECOM=SIMP[1] DUP[2]
Select communication mode.
Select "SIMP" or "DUP" and press the [ENT] key .
INTL CH:001 < TX DUP HI >
TX POWER= HIGH[1] LOW[2]
Select TX power.
Select "HIGH" or "LOW" and press the [ENT] key .
To set other INTL channels.
Rotate CHANNEL knob to select a channel to be set.
To select other mode (USA, WX or Private),
Press the [CH16] key while pressing the a CHNNEL knob.
depending on channel.
Press the [CANCEL] key.
System < Rom version >
V P ID DSC RT CH PO L
(continued on next page)
E4-3
The international channel setting display appears.
(RT program Ver-06 and later)
*PRIVATE Channel mode
P01/ CH:- - - < - - - - - - - ->
PRIV No.SELECT: [<] [>] key
Press the arrow key to select private channel
(P01 to P20) to be set.
Press the [ENT] key.
P01/ CH:001 <UNABLE>
ENABLE=TX[1] RX[2] UN[3]
TX: Transmission and reception available
RX:Reception only
UN:Transmission and reception prohibited
Rotate CHANNEL knob to select a channel to be set.
Press TX[1], RX[2], or UN[3] key, and [Enter] key
P01/ CH:001 < TX SIMP LOW >
TELECOM= SIMP[1] DUP[2]
Select communication mode.
Press SIMP[1] or DUP[2] key, and [Enter] key.
P01/ CH:001 < TX SIMP LOW >
TX POWER= HIGH[1] LOW[2]
Select TX power.
Press HIGH[1] or LOW[2] key, and [Enter] key.
To set other private channels.
Rotate CHANNEL knob to select a channel to be set.
FM-8500
depending on channel.