Table of Contents
Advertisement
PRE-RIDE ALTIMETER CALIBRATION
Whenever you clear ride data between rides or during a ride, you must re-calibrate your Altimeter before you start riding again.
ENG
Otherwise the Altimeter will not function. You could re-calibrate your Altimeter by
●
Recall the Pre-set Altimeter M1 & M2
●
Input a new elevation value
●
Input a new barametric pressure
A) ALTIMETER M1 & M2 OR INPUT ELEVATION VALUES
I . HOW TO RECALL THE PER-SET ALTIMETER M1 & 2?
1) Press both
and
1
2) Altimeter M1 will be displayed, press
3) or press
to advance to the Altimeter M2, press
2
4) or press
to advance to the Manual Input Screen (see Step 6)
2
(if you want to change the pre-set M1 & M2, see page 12, Section of Altimeter Memory 1 & 2 Setup)
II. INPUT A NEW ELEVATION VALUE
5) Continue from the Step 4 (see above)
6) When the "ft" (or "m") begins to flash, press
7) The digits "0000" will appear with the right digit flashing
8) Press
to scroll to the desired number
2
9) Press
to select and advance to the next digit
1
10) Repeat for each digit until the final digit
11) Press
to select the last digit and return to the SPD/ALT Mode.
1
24
simultaneously for 2 seconds in SPD/ALT Mode
2
to select and exit to SPD/ALT Mode
1
1
1
to select and exit to SPD/ALT Mode
to advance to the Elevation Setting
Advertisement
Table of Contents
